Rode In-Line Devices

D-PowerPlug
In Line Cable Mounted Amplifier
 

The D-PowerPlug is effectively a ‘Turbo Charger' for Dynamic microphones! Features an instrumentation grade pre-amplifier circuit, D-PowerPlug will turn any standard dynamic microphone into a high level electronically balanced output device. Using conventional microphones with long multi-core cables results in a dramatic loss of signal strength, and of course sound quality due to cable resistance and capacitance. Powered by standard P48 V, D-PowerPlug can drive cables in excess of 100 m with negligible loss of signal quality or power. Compatible with standard XLR connectors.

Features

D-Power
In-Mic Cable Mounted Preamplifier 
 

The D-Power. A retro-fit instrumentation Preamplifier designed to 'Turbo Charge' your dynamic mics. The same circuit as used in D-PowerPlug. Just pull out the XLR connector on your favorite mic, solder in D-Power, and you have an active, high level drive, dynamic Stage or Broadcast mic. Suits most Dynamic Microphones.

Features

• Instrumentation grade preamplifier
• Balanced input and balanced output
• Can be used with long cable runs with minimum losses
• P48V phantom powered
• Frequency range: 20 Hz ~ 20 kHz (-3 dB)
• Output impedance: 100 Ù balanced
• Power supply voltage: 48V
• Current consumption: 3 ma
• Output connection: XLR 3 PIN Male
• Maximum output voltage: + 11.4 dBu @ 1% THD (8 Vp-p)

Rode mics  |  D-PowerPlug  |  D-Power

• Gain: +20 dB
• Input level: 1 mV
• Output level: 10 mV
• Input impedance: 100 kÙ balanced per arm
• Noise: -116 dB A-Wt RTI
• Maximum input: 0.8 Vp-p
• Input connector: XLR 3 PIN Female
• Pin assignment: Pin 1 GND, Pin 2 Signal(+), Pin 3 Signal(-)
• Dimensions: 0.43"H x 1.97"W x 0.43"D
• Weight: 2.6 oz