|
 APB-DynaSonics
ProRack
ProRack-House and ProRack-Monitor small format mixers
APB-DynaSonics' ProRack small-format mixers incorporate a wealth of
professional features and exceptional performance into 10 rack spaces.
The chassis design features an adjustable connector assembly that freely
rotates and be set to three different angles relative to the front panel.
This allows the input and output jacks to be properly positioned whether
the mixers are mounted in a vertical rack, slant rack or used on a desk
top.
ProRack's audio design is based on our critically acclaimed Spectra
Series consoles. This includes the use of minimum phase-shift circuitry,
expressive EQ and integrated mic preamplifiers, both used in a proprietary
front end circuit. In addition to superior audio quality, reliability
and serviceability are also primary design criteria for ProRack. Internal
construction is based upon a passive mother board and multiple active
daughter boards. The active electronics of a single input channel is designed
onto two field-replaceable electronics modules. The power supply is a
plug-in assembly that can be easily field-replaced by removing 6 screws.
Special care has been taken to reduce RF interference and eliminate any
Pin-1 related problems.
Features |
ProRack-House (H1020)
- 12 Mono input channels and 4 Dual-Mono/Stereo input channels. 20 Mic
preamplifiers in total.
- 48 volt Phantom Power switch, Mic/Line switch, Mic Pad switch, and
Polarity Reverse switch.
- Variable frequency high-pass filters are included on all input channels
(Mono and Stereo) with a 20Hz to 400Hz sweep range at a 12dB per octave
attenuation rate.
- Fixed high and low frequency EQ bands and two mid-sweep EQ bands with
one-octave bandwidth. This EQ includes an EQ On switch with LED indicator.
The Stereo channels feature fixed high and low frequency EQ bands and
a single mid-sweep EQ based on that same Spectra circuitry.
- 6 aux send controls; each pair of sends switchable between a pre or
post fader source. In the pre-fader position, an additional front panel
switch determines if that pre-fader signal is derived pre or post EQ.
Aux controls 5 and 6 may be switched to become a stereo pair.
- Left-Right, Center and Mono mix bus assignment and assignment to analog
subgroups 1-2 and 3-4 with all outputs (including aux outputs) having
balanced XLR, bus input and TRS insert connectors.
- Left-Right, Center and Mono mix output level can be switched from
line level to mic level.
- Internally illuminated Mute and PFL/AFL switches are provided along
with 6-segment LED metering and high quality 100mm faders.
- Adjustable connector assembly freely rotates and can be set to three
different angles relative to the front panel.
|
ProRack-Monitor (M1016)
- 16 Mono input channels - generating up to 8 Stereo Mixes (perfect
for in-ear type monitor systems) plus 2 additional Mono Mixes from each
input channel.
- 48 volt Phantom Power switch, Mic/Line switch, Mic Pad switch, and
Polarity Reverse switch.
- Variable frequency high-pass filters are included on all input channels
with a 20Hz to 400Hz sweep range at a 12dB per octave attenuation rate.
- Fixed high and low frequency EQ bands and two mid-sweep EQ bands with
one-octave bandwidth. This EQ includes an EQ On switch with LED indicator
and is based on Spectra EQ circuitry.
- 8 Stereo Mixes, with each input channel having separate level and
pan controls to each stereo mix, plus two Mono Mixes which are switch
selected between pre or post the channel's master level control.
- All 18 outputs (in total) have balanced XLR connectors, TRS Insert
points (pre AFL solo system), and (on the first 16 outputs) balanced
line input connectors which route in pairs to each stereo mix and are
controlled by a front panel fader within each of the 8 stereo master
output control sections.
- Internally illuminated Mute and PFL/AFL switches are provided along
with 6-segment LED metering and channel master level control.
- Built in passive splitter system with Pin-1 Lift switches.
- Both ProRack versions are covered by a three year limited U.S. warranty
|
