A7 | ANF10 | P11A | P22A | P33A | Sub8 | Sub10 MKII | Sub12 | Sub20 | Sub24

ADAM Audio A7
2-way, active studio monitor with A.R.T. Tweeter

Our Low Price:   Call or E-mail

ADAM Audio ANF10
2-way, passive studio monitor with an A.R.T. Folded ribbon tweeter - requires amp

Our Low Price:   Call or E-mail

ADAM Audio P11A
The P11A is a two-way shielded active monitor that produces unique imaging and outstanding transient response. Designed for small to mid-sized project studios; it can also be used in any small powered monitor application.

Our Low Price:   Call or E-mail

ADAM Audio P22A
The ADAM P22A monitor is a two-way shielded active near/midfield monitor designed for applications where deeper bass and louder volumes are needed. Featuring superb imaging as a result of ADAM’s proprietary A.R.T. folded ribbon tweeter, the P22A is ideally suited for project studios, recording and broadcast facilities.

Our Low Price:   Call or E-mail

ADAM Audio P33A
The P33A is a shielded near/midfield monitor and has three 100W amplifiers that deliver outstanding dynamic performance. It can be used either horizontally or vertically, so that very flexible positioning within the studio is possible.

Our Low Price:   Call or E-mail

ADAM Audio Sub8
The Sub8 houses an excellent 8" woofer with a large 50mm voicecoil, and is driven by a 160W ICE Power amp. This amp stays cool while handling maximum power levels even if they are sustained.

Our Low Price:   Call or E-mail

ADAM Audio Sub10 MK2
To fill out the low end of a stereo or 5.1 surround system, the Sub10 delivers stunning bass performance. The unit comes with both balanced (XLR) and unbalanced (RCA) connectors. It is possible to adjust the bandwidth of the woofer and the connected full-range speakers separately in order to allow the Sub10 to be used with many different satellites.

Our Low Price:   Call or E-mail

ADAM Audio Sub12
This larger unit houses a 12" woofer capable of producing a 3dB higher SPL max output. The wide bass reflex tube fires downwards; due to its size and construction ventilation noise is successfully avoided.

Our Low Price:   Call or E-mail

ADAM Audio Sub20
The Sub20 is meant to reproduce LFE or other low frequency signals above 25Hz in medium sized or larger control rooms. It is equipped with 2 - 10" drivers that are mounted at the opposite sides of the cabinet. Due to this alignment the forces applied to the cabinet are opposite to each other and consequently compensate themselves, so that the cabinet stays much quieter than with conventional arrays.

Our Low Price:   Call or E-mail

ADAM Audio Sub24
The Sub24 is equipped with 2 long throw 12“ drivers that are mounted at opposite sides and meant to reproduce LF signals above 22Hz. Distortion is drastically reduced that way, the clarity of the signal is improved especially at higher levels. There are 2 downfiring bass reflex tubes that because of their size and construction successfully avoid ventilation noise.

Our Low Price:   Call or E-mail